For laser users

SVG and DXF for laser engravers

The laser engrave preset is selected. Import the SVG into Glowforge, LightBurn, or xTool software, or take the DXF if your program wants polylines.

Image converter

Drop a PNG, JPG, or WebP

You can also paste an image, or pick a file.

Nothing is uploaded. The picture stays in this browser tab.

Maker preset

A few flat tones for engrave regions. This is not a photo halftone, and it does not set power or speed.

Drops islands smaller than this many pixels on a side. 0 keeps every speck.

Clears the color that dominates the edge, including a near-white edge. Spots of that color inside the design are cleared too.

Your layered preview shows up here. Hide a layer to leave it out of the download.

SVG keeps the curves. DXF writes polylines in millimetres at 96 pixels per inch, with curves flattened and Y flipped upright. PDF is one page, 1 pixel = 1 point. The zip is one SVG file per visible layer.

A Pro plan is planned for people who want unlimited layered files. It is not for sale, and there is no price yet. What that means

What you can send to the laser

This page makes vector regions from a picture. Each color is a layer you can assign to a fill, a score, or a cut after import. That is a good file for a logo on a cutting board, a shop sign, or a simple icon. It is a bad file for a photograph. The converter does not dither, and it does not build a grayscale raster. If the job is a portrait, use the image mode in your laser software and skip this tool.

Glowforge imports SVG more reliably than DXF, so download SVG for that machine. LightBurn and xTool software will take the SVG or the DXF. The DXF is in millimetres, 96 pixels per inch, with Y flipped upright and curves turned into polylines. Measure one edge after import. If the part is off by 25.4, the program assumed inches. Scale once. The DXF guide covers holes and shared edges. The engraving guide covers presets and thin type.

Before you press start

Turn background removal on when the artwork sits on white. Otherwise the white field becomes a layer, and a fill engrave will burn the whole sheet. Hide that layer in the preview if it is still there, then download. Set the real part width in the laser software. Assign an operation to each layer. Run a small test on the same material. Power, speed, and kerf are not in the file, because they depend on your machine. A diode and a CO2 tube will not share a number, and this site will not invent one.

Switch to the laser cut preset when you only want a closed outline in two colors. Keep the engrave preset when several fills share one board. Either way, the picture stays in the browser. Nothing is uploaded for tracing.

Questions

Is this a photo engrave?

No. You get flat color regions. Photographs should use the raster or grayscale image mode in your laser software. Use these SVGs for logos, signs, icons, and other simple artwork.

SVG or DXF?

Glowforge prefers SVG. LightBurn and xTool software can use SVG or DXF. The DXF is polylines in millimetres with curves flattened. The SVG keeps curves.

Where are power and speed?

They are not in the file. Set them in the laser software for your tube and your material, and test on scrap.